LCP-0
5007-1
NOTICE
This publication is the proprietary of SHARP and is copyrighted, with all rights reserved. Under the copyright laws, no part of
this publication may be reproduced or transmitted in any form or by any means, electronic or mechanical for any purpose, in
whole or in part, without the express written permission of SHARP Express written permission is also required before any use of
this publication may be made by a third party.
The application circuit examples in this publication are provided to explain the representative applications of SHARP's devices
and are not intended to guarantee any circuit design or permit any industrial property right or other rights to be executed. SHARP
takes no responsibility for any problems related to any industrial property right or a third party resulting from the use of
SHARP's devices, except for those resulting directly from device manufacturing processes.
In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that occur in
equipment using any of SHARP's devices, shown in catalogs, data books, etc. Contact SHARP in order to obtain the latest
device specification sheets before using any SHARP's device.
SHARP reserves the right to make changes in the specifications, characteristics, data, materials, structures and other contents
described herein at any time without notice in order to improve design or reliability. Contact SHARP in order to obtain the latest
specification sheets before using any SHARP's device. Manufacturing locations are also subject to change without notice.
Observe the following points when using any device in this publication. SHARP takes no responsibility for damage caused by
improper use of the devices.
The appropriate design measures should be taken to ensure reliability and safety when SHARP's devices are used for equipment
such as:
· Transportation control and safety equipment (i.e., aircraft, trains, automobiles, etc.)
· Traffic signals
· Gas leakage sensor breakers
· Alarm equipment
· Various safety devices etc.
SHARP's devices shall not be used for equipment that requires extremely high level of reliability, such as:
· Military and space applications
· Nuclear power control equipment
· Medical equipment for life support
Contact a SHARP representative, in advance, when intending to use SHARP's devices for any "specific" applications other than
those recommended by SHARP.
Contact and consult with a SHARP representative if there are any questions about the contents of this publication.
LCP-05007-2
(1) Application
This literature applies to LQ038Q7DB03R.
(2) Overview
This module is a color reflective and active matrix LCD module incorporating amorphous silicon TFT
(Thin Film Transistor), named AD-TFT(Advanced TFT). It is composed of a color TFT-LCD panel, driver
ICs, an FPC, a back light, and a back sealed casing. It isn't composed control circuit. Graphics and texts
can be displayed on a 240×3×320 dots panel with 262,144 colors by supplying.
Optimum view angle is 6 o'clock. An inverted display mode is selective in the vertical or the horizontal
direction.
3Mechanical specifications
Table 1
Parameter Specifications
Units
Remarks
Screen size (Diagonal)
9.54 [3.78 ] Diagonal
cm
Display active area
57.6H×76.8V
mm
Touch panel active area
57.9H×77.8V
mm
Pixel format
240(H)×320(V)
(1 pixel = R+G+B dots)
pixels
Pixel pitch
0.24H×0.24V
mm
Pixel configuration
R,G,B vertical stripe
Unit outline dimension
69.0(W)×88.6(H)×3.4(D)
mm
Note3-1
Mass 42
Surface hardness
(Touch panel)
3H
Note 3-1
Excluding FPC. For detailed measurements and tolerances, please refer to Fig. 1.
(4)Pixel configuration
Display area
FPC
(240,1)
(1,1)
(240,320)
(1,320)
R G B
PDF 
ZIP
