CS8813
General Purpose USB2.0-to-ATA Bridge Controller with
Embedded PHY
sales@myson.com.tw
www.myson.com.tw
Rev. 1.0 June 2003
page 1 of 41
Myson Century, Inc.
Taiwan:
No. 2, Industry East Rd. III,
Science-Based Industrial Park, Hsin-Chu, Taiwan
Tel: 886-3-5784866 Fax: 886-3-5784349
USA:
4020 Moorpark Avenue, Suite 115
San Jose, CA, 95117
Tel: 408-243-8388 Fax: 408-243-3188
FEATURES
· Fully compatible with USB specification 2.0
- Support full-speed (12M bits/sec) or
high-speed (480M bits/sec) devices with
multiple configurations and multiple interfaces
- Support all USB standard commands,
including suspend and resume detection logic
- Support USB 2.0 TEST mode features
· Supports 5 endpoints
- All endpoints share one on-chip 4K bytes SRAM
buffer and the size of each endpoint is
configurable
- Default control endpoints (EP0) with up to
64-byte buffer on either TX or RX direction
- An interrupt OUT endpoint (EP1) and an
interrupt IN endpoint (EP2)
- A bulk OUT endpoint (EP3) and a bulk IN
endpoint (EP4): up to 512 bytes data payload for
full/high speed bulk endpoint
- Unused endpoint can be disabled
· Embedded USB 2.0 transceiver
- Integrated bit stuffing/unstuffing and stuff
error detection
- NRZI (Non-Return-to-Zero Inverted)
encoding/decoding
· USB Mass Storage Class Bulk-Only
Specification Compliant (Version 1.0)
· Support Bus Powered and Self Powered modes
· Support true ATA compatible interface
- Complies with ATA-7 Specification (PIO mode
0,3,4, Multiword DMA mode 0~2, UDMA
mode 0~6)
- 8-bit/16-bit Standard PIO mode interface
- 16-bit Multiword DMA mode and UDMA mode
interface (Ultra 133)
· Embedded 8-bit microprocessor with on-chip 8K
x 14 program ROM and optional external 16K x
14 program ROM/Flash memory
· Flexible 32-bit I/O interfaces providing maximum
versatility with ROM mask changeable firmware
· Firmware to support ATA hard disk driver is
provided
· 12MHz external clock input to provide better
EMI
· Low power with operation voltage 3.3V with 5V
tolerance I/O pads
· Available in 64-pin LQFP (10mm x 10mm)
production package and 128-pin QFP (14mm x
20mm) development package
GENERAL DESCRIPTION
The CS8813 is a single chip USB (Universal Serial Bus)
2.0 Mass storage class peripheral controller intended for
use with standard ATA hard drivers. The device consists
of a USB 2.0 PHY and SIE, FIFO buffers, embedded
microprocessor with expanded external program
ROM/Flash memory, and ATA compatible interface.
The CS8813 uses 12MHz crystal to reduce the EMI
issue. With flexible 32-bit I/O interface, the CS8813
can be programmed to fit different situations in the
USB 2.0 high speed mass storage class applications
such as HDD, Disk on a chip, etc.
PDF 
ZIP