SLE 66C40S Short Product Information

Ref.: SPI_SLE 66C 40S_1001

This document contains preliminary information on a new product under development.
Details are subject to change without notice.
Revision History:

Current Version 10.01

Previous Releases:
Page

Subjects (changes since last revision)

Important: Further information is confidential and on request. Please contact:

Infineon Technologies AG in Munich, Germany,
Security & Chip Card ICs,
Tel :

+49 89 234-80000

Fax

+49 89 234-81000

E-Mail:

security.chipcard.ics@infineon.com

Edition 2001

Published by Infineon Technologies AG, CC Applications Group
St.-Martin-Strasse 53, D-81541 München

Attention please!
The information herein is given to describe certain components and shall not be considered as warranted
characteristics.
Terms of delivery and rights to technical change reserved.
We hereby disclaim any and all warranties, including but not limited to warranties of non-infringement, regarding

circuits, descriptions and charts stated herein.
Infineon Technologies is an approved CECC manufacturer.

Information
For further information on technology, delivery terms and conditions and prices please contact your nearest Infineon
Technologies Office in Germany or our Infineon Technologies Representatives world-wide (see address list).

Warnings
Due to technical requirements components may contain dangerous substances. For information on the types in
question please contact your nearest Infineon Technologies Office.
Infineon Technologies Components may only be used in life-support devices or systems with the express written
approval of Infineon Technologies, if a failure of such components can reasonably be expected to cause the failure of

that life-support device or system, or to affect the safety or effectiveness of that device or system. Life support devices
or systems are intended to be implanted in the human body, or to support and/or maintain and sustain and/or protect
human life. If they fail, it is reasonable to assume that the health of the user or other persons may be endangered.

SLE 66C40S

Short Product Information

3 / 7

10.01

16-bit Security Controller with
32-Kbyte ROM, 1280 Byte RAM and
4-Kbyte EEPROM

Features

16-bit microcomputer in 0.6 µm CMOS
technology

Instruction set opcode compatible with
standard SAB 8051 processor

Enhanced 16-bit arithmetic

Additional powerful instructions
optimized for chip card applications

Dedicated, non-standard architecture
with execution time six times faster
than standard SAB 8051 processor

31.5-Kbytes User ROM for application
programs

512-bytes reserved ROM for Resource
Management System (RMS) with
intelligent write/erase routines

4-Kbytes EEPROM as program/data
memory

1280 bytes RAM

True random number generator
(RNG)

Interrupt module for I/O interface

CRC Module

16-bit timer with 8-bit prescaler

Power saving sleep mode

Clock freq. = int. freq.: 1 to 7.5 MHz

Contact configuration and serial
interface in accordance with ISO 7816

Supply voltage range: 2.7 V to 5.5 V

Current consumption < 10 mA at 5 MHz
and 5.5 V

Temperature range: -25 to +70°C

ESD protection larger than 4 kV

Testmode

Irreversible Lock - Out of testmode

EEPROM

Reading, erasing and writing byte by byte

Flexible page mode for 1 to 16 bytes
write/erase operation

32 bytes security area

Write time 3.62 ms, erase time 1.81 ms

Programming time adaptable to clock
frequency

Minimum of 500,000 write/erase cycles

Data retention for a minimum of ten years

EEPROM programming voltage
generated on chip

Security Features

Operation state monitoring mechanism

Low and high voltage sensors

Frequency sensors and filters

Memory Security

16 bytes security PROM, hardware
protected

Unique chip identification number for
each chip

MED memory encryption/decryption
device for XRAM, ROM and EEPROM

True Random Number Generator with
Firmware test function

Security optimised layout and layout
scrambling

user settable additional encryption key
for EEPROM

Move code blocking (from EEPROM)

Support

HW-& SW-Tools (Emulator, ROM
Monitor, Card Emulator, Simulator,
Softmasking)

Application notes (e.g.: T=0, T=1, DES,
RNG, etc.)

SLE 66C40S

Short Product Information

4 / 7

10.01

Anti Snooping

HW-countermeasures against
SPA/DPA-, Timing- and DFA-attacks
(differential fault analysis DFA)

CRC - Module

Non standard dedicated Smart Card
CPU Core

Development Tools Overview

Short Product Information Software
Development Kit SDK CC

Short Product Information Card
Emulator SCE66

Short Product Information ROM
Monitor SRM66

Short Product Information Emulator
SET66 Hitex or SET66 KSC

Short Product Information Smart Mask
Package

Supported Standards

ISO/IEC 7816

EMV 2000

GSM 11.1x

ETS I TS 102 221

Document References

Confidential Data Book SLE 66CxxS

Confidential Instruction SLE 66CxxS

Confidential Quick Reference
SLE 66CxxS

Qualification report

Chip delivery specification for wafer with
chip-layout (die size, orientation,...)

Module specification containing
description of package, etc.

Qualification report module

SLE 66C40S

Short Product Information

5 / 7

10.01

Ordering Information

Type

Package

Voltage
Range

Temperature
Range

Frequency Range

SLE 66C40S

2.7 V - 5.5 V

25°C to + 70°C 1 MHz - 5 MHz @ 5V

1 MHz - 4 MHz @ 3V

SLE 66C40S-T85

2.7 V - 5.5 V

25°C to + 85°C 1 MHz - 5 MHz @ 5V

1 MHz - 4 MHz @ 3V

SLE 66C40S-V5

4.5 V - 5.5 V

25°C to + 70°C 1 MHz - 5 MHz

SLE 66C40S-V5-T85

4.5 V - 5.5 V

25°C to + 85°C 1 MHz - 5 MHz

SLE 66C40S-V5-F7

4.5 V - 5.5 V

25°C to + 70°C 1 MHz - 7.5 MHz

available as wire-bonded module (M4) for embedding in plastic cards or as die (C) for customer packaging

Part Number SLE66C40S